 Injection Pressure
This result displays the plastic injection pressure when the selected point was filled. The
result uses a range of colors to indicate the highest pressure( colored red) through
the region of the lowest pressure (colored blue). The plastic injection pressure results can be
used in conjunction with the pressure drop results. For example: even if a section of
the part has an acceptable pressure drop, the actual injection pressure in the same area
could be too high and cause over-packing. The results can be used to implement other
parameter changes to improve filling such as, higher or lower injection pressure, moving
gate location, changes to the parts geometry, of possible selection of a different polymer.
|
866-886-2626